Different Stages in the Growth of Passion Fruit

Passion fruit is ideally grown in subtropical and tropical regions and need plenty of sunlight for a healthy growth. However, it can be grown in many other parts too with controlled soil and climatic conditions.

Panama Red Passionfruit Harvest
Panama Red Passionfruit Harvest

Passion fruit can be cultivated by two methods – first being through germination of seeds and the other being grafting of plant.

Preparation for planting

Any plant that you wish to grow needs planting in pot or ground. In the case of passion fruit, the seeds from a ripe, harvested fruit can be used after removing them from the pulp, washing and drying them for 3-4 days.

The freshly picked seeds germinate faster and better than the dried stored ones. A pot with mixture of coarse sand, manure and topsoil should be made ready for the seeds to be planted. The pot should be approximately half filled with the soil.

Digging furrows in the soil for plantation also ensure that the seeds are not drenched in water and there is sufficient scope for seepage. Sow the seeds at higher level in soil at least 1 cm apart from each other and then cover them gently with a thin layer of soil. This is necessary so that the seeds get good supply of warmth of sunlight for germination. Water the seeds immediately, taking care to see that the seeds are just moistened and not totally soaked in water. Keep an eye on the pot in next few days and as you see top layer dried, sprinkle some water to wet it.

This will enable the seeds to germinate quickly within 10-20 days. Since they are planted at higher level, there is scope for the roots to grow firmly in the soil. When you see that the seedlings have grown 8 to 10 inches tall, you can safely transplant them in the ground where you wish to cultivate them.

As far as planting through grafting is concerned, prepare a pot with three parts fertile soil with a part of topsoil. After mixing them thoroughly, plant the cutting in it. The cutting does not have roots and thus absorbs moisture from atmosphere for its growth. Hence, there is no need to water the cutting excessively nor does the soil have to retain the moisture.

For a good crop, it is essential that the cutting is from a healthy plant. Select the new, young portion of a mature vine and snip it with at least three buds intact. The cut should be directly below the lowest bud, as this is from where the roots will grow in the soil. Plant the cutting in the prepared sand bed immediately after cutting to prevent drying up.

After this stage, it is of prime importance to keep the cutting under humid condition by covering the pot with a plastic sheet and keeping it in sunlight. The roots are formed within 1-2 weeks and then it is ready for transplanting in solid ground.

Choose the right place

For a healthy plant growth, the space utilized for planting should be ideal to suit the particular plant growth. In case of Passion fruit, the plant in consideration is a vine and thus needs sufficient place to spread. The spot chosen for planting should be away from heavy root trees and weeds. It is necessary to clear the weeds from the portion before planting. There should be full sunlight (6 hours a day) and a support nearby for the vine to climb on. You can have it close to fencing or erect a trellis for the purpose.

Care and harvesting

It is essential to put fertilizers from time to time, remove the weeds and water the plants daily for a good crop. Spray the leaves with pesticides to protect from diseases. Soil check for pH balance of 6.5-7.5 is necessary too. Roots need to breathe easily for a healthy growth, so loosen the soil periodically and add coarse sand for aeration.

The vine starts bearing fruits in a year or one and half year, depending upon the quality. Both the varieties, purple and yellow, are green in color in initial stages and as they ripen they change the color. Once you see some wrinkles on the fruit it is ready for harvesting and consumption.